Vector Lumbar Support

The Vector Lumbar Support provides targeted, vectored compression through a dual pulley cinching system. When you pull the handles, the cinching system pulls the lumbar panel forward into your spine, providing needed support and instantly reducing pain. The lumbar panel can be adjusted left or right with the pulley handles for customized, targeted compression. The Vector's lumbar panel also includes a pocket for a hot/cold therapeutic gel pad. The gel pad (included), can be placed in the microwave for soothing heat, or in the freezer for pain-relieving cold. The Vector is designed to be lightweight and low-profile so it can be worn discreetly under your clothes.

Position the hand pulls

– Before putting on the Vector, ensure that both hand pulls are retracted all the way back on the side panels. This allows for better compression when you engage the cinching mechanism.

Wrap the belt around your waist

– With your right hand, hold the end with the black velcro hook. With your left hand, lay the left panel against your stomach, then press the right panel on top of the left. Belt should be snug, not tight.

Apply compression

– Grasp both of the hand pulls and pull forward while tightening your abdominal muscles. Press the hand pulls firmly against the belt to attach.

Instructions for hot/cold gel pad

– The foam pad on the lumbar panel includes a pouch to hold the hot/cold gel pads. After heating or freezing a gel pad, insert it into the pouch and wear as directed above.

TO HEAT: Place the gel pad flat in the microwave for 30-60 seconds. Heat until warm, not hot. Heat will discharge in 20-30 minutes.

TO FREEZE: Place the gel pad flat in the freezer for at least an hour. Cold will discharge in 15-20 minutes.